Introduction

Two inputs and two outputs for Clipsal C-Bus systems in a small self-powered footprint? Read on!

The Vivisys EasyConnect Digital I/O Interface board works in conjunction with the standard Clipsal 5102BCLEDL Bus Coupler to make connecting your low voltage devices a breeze! The standard bus coupler connects to floating switches only, and powers two LEDs, but the EasyConnect board extends this by allowing the connection of on/off non-floating voltage sources, and turning the LED outputs into two solid state relays for operating your gadgets!

No power supplies or din rail units needed for your interfacing tasks. Just run a pink C-Bus cable to the item and connect up with the EasyConnect board.

Download the data sheet here.

  • The EasyConnect board
  • EasyConnect board with C-Bus Bus Coupler

Making it easy, one EasyConnect board (used with a standard Clipsal 5102BCLEDL Bus Coupler) brings the following to the C-Bus system:

  • Two non-floating on/off DC voltage inputs, typically in the 5 to 48 V DC range.
  • Two solid state relay outputs for driving loads up to 48 V DC and 0.30 A.
  • The ability to easily connect devices such as garage door openers, sliding gates, door locks, water sensors, etc.
  • Garage door opener
  • Sliding or opening gates

Additionally, the EasyConnect board:

  • Is powered from the 5102BCLEDL Bus Coupler.
  • Has a detailed application note available showing how to use it to operate a typical garage door opener.

Get more information from the following documents:

  • Data sheet
  • Application note
  • Installation Instructions